CyberData 011305 Dokumentacja Pobierz pdf (Strona 32)

Operations Guide 930943A CyberData Corporation

Installing the VoIP Indoor Intercom

Configure the Device

Activate Relay During Ring When selected, the relay will be activated for as long as

the call is active.

NOTE: When the phone is set to Auto Answer, it will not

ring and this option does nothing.

Activate Relay During Night Ring Check this box to activate the relay for as long as a Night

Rin

g tone is r

inging.

Activate Relay While Call Active When selected, the relay will be activated for as long as

the call

is activ

Activate Relay on Button Press When selected, the relay will be activated when the Call

Button is pressed.

Relay on Button Press Timeout (in seconds) Type the desired time (in seconds) that you want the relay

to activate after the Call Button is pressed (1 character

limit).

Miscellaneous Settings

Auto-Answer Incoming Calls When selected, the device will automatically answer

incoming calls.

When Auto Answer is Off, the device will play a ringtone

through the Intercom speaker until someone presses the

button.

Button Lit When Idle When selected, the Call Button remains lit when idle.

Button Brightness (0-255) Type the desired Call Button LED brightness level (0-255).

Play Ringback Tone When selected, you will hear a ringback tone while making

a call.

Enable Push to Talk This option is for noisy environments. When enabled, the

microph

one will be muted normally. When the button is

pressed and held, it will unmute the microphone and allow

the operator to send audio back.

NOTE: When En

able Push to Talk is enabled, you cannot

stop an active call with the call button. The device on the

other end will need to end the call.

NOTE: Enable Push

to Talk will not work on some older

hardware.

Click the Save button to save your configuration settings.

Note: You need to reboot for changes to take effect.

Click on the Test Audio button to do an audio test. When

the Test Audio button is pressed, you will hear a voice

message for testing the device audio quality and volume.

Click on the Test Microphone button to do a microphone

test. When the Test Microphone button is pressed, the

following occurs:

1. The device will immediately start recording 3 seconds of

audio.

2. The device will beep (indicating the end of recording).

3. The device will play back the recorded audio.

Table 2-7. Device Configuration Parameters (continued)

Web Page Item Description

VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 86 87

Komentarze do niniejszej Instrukcji

Brak uwag

CyberData 011305 Dokumentacja Strona 32

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Domofony CyberData 011305